Does the Cloud Node automatically discover my wireless controllers?

No, you will need to activate Discovery mode. Once the Cloud Node is in Discovery mode, it will find any nearby wireless controllers that are powered up and sending a WiMAC signal. 

To enable discovery mode, select the customer you wish to edit.

Then select the Cloud Node for adding to the wireless door controllers.

Next, select the system Configuration icon. 

Now select the WIRELESS tab.

Once the wireless tab is selected, you’ll see the discovery icon (magnifying glass icon) appear in the bottom right corner of your screen. Tap on the Discovery icon.

The Cloud Node is now placed into discovery mode and it will begin finding all the wireless door controllers. All of the wireless devices will appear after a few seconds.

NOTE: If the Cloud Node doesn't power up properly (there is no red light from behind the shroud area), make certain that none of the wires are shorting out, including the battery connection cables. This can cause the main board to not power up.