Wiring and Triggering a Piezo for a Door Prop Alarm on an Eight io – ProdataKey, Inc.

ProdataKey does not require proprietary readers. Door controllers accept a Wiegand input, including biometric readers and keypads.

(A) Main Reader - Mounted at the door with a 22/5 or 22/6 wire running to the door controller. Wire the reader to the controller as shown above. Check polarity and voltage carefully prior to powering the controller.

(B) Piezo - A piezo trigger for tamper or door prop alarm connected to (-) of AUX relay and to the B connection of the reader. The piezo buzzer can be configured with software rules. The piezo device can be connected to the door controller to be triggered based on specific events in the system. The most typical is a door forced or “prop” alarm.

To program the piezo alarm for a propped door, select the Trigger event On Door Propped (the door is held or propped open longer than the prop Trigger period).

After being triggered and sounding the prop alarm, it can be cleared (turned off) using the Event option All Prop Clear.

Technical Support

Should you require any technical assistance, please contact our knowledgeable ProdataKey Support staff. Your support queries covering hardware, software installation, trouble tickets, troubleshooting, return merchandise authorization (RMA), or any other questions will be addressed as immediately as possible.

Phone: 801.317.8802 option #2 or direct at: 801.206.4086
Email: support@prodatakey.com
Direct Dealer Support Line: 801.206.4086

ProdataKey, LLC - 67 West 13490 South, Draper, Utah 84020 United States